[Mar 20, 2024] Valid H35-211_V2.5-ENU Test Answers & Huawei H35-211_V2.5-ENU Exam PDF
Realistic H35-211_V2.5-ENU Exam Dumps with Accurate & Updated Questions
NEW QUESTION # 55
In order to improve link reliability, the LT device configures the Time delay protection group through two uplink ports 0/19/0 and 0/20/0. Which of the following commands is optional?
- A. huawei ( config ) =protect-group 0 protect-target sth-nni port work mode time delay
- B. huawei ( protect-group-0 ) h protect-group member port 0/19/0role work
- C. huawei ( protect-group-0 ) a protect-group enable
- D. huawei ( config ) #interface giu 0/ 19 huawei ( config-if-giu-0/19 ) h offline-tx-off-time0500
Answer: D
NEW QUESTION # 56
In ACL, if you need to filter data packets based on their source IP address information, destination IP address information, port number and other information, then the created ACL number range is:
- A. 3000~3999
- B. 2000~2999
- C. 4000~4999
- D. 5000~5999
Answer: A
NEW QUESTION # 57
During the SIP voice service provisioning process, what is the port corresponding to the default VLAN on the user side of the ONT?
- A. FE
- B. POST
- C. ETH
- D. IPHOST
Answer: B
NEW QUESTION # 58
Which of the following conditions will not trigger GPON Type B single-homing protection switching?
- A. Deterioration of trunk optical cable line quality
- B. Trunk fiber break
- C. Multiple ONU are attached to the optical splitter, and a single ONU is offline
- D. OLT active PO port fault
Answer: C
NEW QUESTION # 59
When the ONT fails or the hardware is upgraded, the ONT needs to be replaced, and the ONT service needs to be removed on the OLT, and then the ONT terminal is removed, and the new ONT service is registered and configured.
- A. False
- B. Ture
Answer: A
NEW QUESTION # 60
The automatic discovery methods provided by esight include network segment method, ARP method and routing method. At the same time, it supports the creation of the network segment or IP address of the device that does not need to be accessed as an exclusion list, and the network segment or IP address configured in the exclusion list is automatically passed during the automatic discovery of the device.
- A. False
- B. True
Answer: B
NEW QUESTION # 61
The automatic discovery methods provided by sight include network segment method, ARP method and routing method. At the same time, it supports the creation of the network segment or IP address of the device that does not need to be connected as an exclusion list. The network segment or IP address configured in the exclusion list is automatically skipped during the self-discovery process.
- A. False
- B. Ture
Answer: B
NEW QUESTION # 62
Which of the following belongs to OLT uplink networking protection? (Multiple choice)
- A. TYPE C protection
- B. OLT uplink VRRP dual-homing protection
- C. TYPE B protection
- D. OLT Uplink Aggregation Protection
Answer: B,D
NEW QUESTION # 63
The data multiplexing mode of 10G GPON is similar to GPON, and TDMA technology is still used in the upstream.
- A. False
- B. True
Answer: B
NEW QUESTION # 64
What technologies can be used to avoid congestion in OLT? (Multiple choice)
- A. RED
- B. DPQ
- C. WFQ
- D. WRED
Answer: A,D
NEW QUESTION # 65
View the protection configuration on the OLT side as follows.
huawei ( config ) #protect-group 0 protect-target gp on-uni-port work mode time delay
huawei ( protect-group-0 ) #protect-group member port 0/5/0role work
huawei ( protect-group-0 ) #protect-group member port 0/5/1role protect
huawei ( protect-group-0 ) #protect-group enable
According to the above information, which of the following statement is correct? (Multiple choice)
- A. When port 0/5/0 fails, the system can automatically switch to port 0/5/1 to continue accessing services
- B. After creating a protection group, the default status of the protection group is disabled, and you need to command protect-group enab1e to enable the protection group
- C. GPON Type B single-homing protection is configured
- D. The member ports of this protection type must be the same as the ports on the GPON board
Answer: A,B,C
NEW QUESTION # 66
Which of the following descriptions are wrong? (Multiple choice)
- A. Use the display esl online-info command to query the local and remote signaling port numbers.
- B. Use the mg-software parameter t command to modify the digitmap matching method.
- C. Under the SIP protocol, the default matching method is the longest match.
- D. Use the protocol1 support t command to modify the voice protocol supported by the device.
Answer: A,C
NEW QUESTION # 67
In the GPON network, if the ONU receives too much light, which of the following tools can be used to adjust? (Multiple choice)
- A. Adjustable Optical Attenuator
- B. Multimeter
- C. Fixed light attenuation
- D. Red light pen
Answer: A,C
NEW QUESTION # 68
OLT equipment supports the use of authority templates to control the programs that the group plug-in user can watch.
- A. False
- B. True
Answer: B
NEW QUESTION # 69
Which of the following options is correct about congestion management?
- A. If the low-priority queue uses PQ and the high-priority queue uses DWRR, the packets in the low-priority queue will be sent first.
- B. When using DWRR, the larger the packet size, the larger the actual egress bandwidth obtained.
- C. When using the DWRR method, the weight ratio of each queue can be adjusted, but the total size is a fixed value.
- D. When using the PQ mode, if the packet carrying priority is higher, the time it is sent from the port will be earlier.
Answer: D
NEW QUESTION # 70
When an FTTH user has a "no power off hook" phenomenon, what are the possible reasons? (Multiple choice)
- A. Phone failure
- B. OLT failure
- C. Line failure between ONU and phone
- D. POTS port failure
Answer: A,C,D
NEW QUESTION # 71
What is the downlink wavelength in the 10GGPON system?
- A. 1310nm
- B. 1577nm
- C. 1490nm
- D. 1270mm
Answer: B
NEW QUESTION # 72
What indicators are included in the QoS of the GPON system? (Multiple choice)
- A. Packet Loss Rate
- B. Jitter
- C. Bandwidth
- D. Delay
Answer: A,B,C,D
NEW QUESTION # 73
In order to prevent network monitoring in the GPON system, the most used method is:
- A. Use physical transmission (non-network)
- B. Wireless network transmission
- C. Information encryption
- D. Use dedicated line transmission
Answer: C
NEW QUESTION # 74
Users report that IPTV has a long time delay when changing channels. In order to improve the experience of channel switching for general users, the program pre-join function can be configured. Which of the following configurations can realize program pre-join?
- A. Huawei (config) #igmp program static ip 224.x.x.x anable
- B. huawei(config)#ml ticast-vlan x Huawei (config-mwlan x) #igmp program add ip 224.x.x.x prejoin enable
- C. huawei (config) mlti cast-vlan x huawei (config-mlan x) igmp program static ip 224.x..x enable
- D. huawei ( config ) #igmp program add ip 224.x.x.x prejoin an able
Answer: B
NEW QUESTION # 75
The protocol used to manage multicast membership is?
- A. PIN-DH
- B. PIN-SH
- C. MSDP
- D. IGMP
Answer: D
NEW QUESTION # 76
......
The HCIP-Access V2.5 exam covers a wide range of topics, including network access technologies, network access security, network access QoS, and network access management. Candidates who successfully pass H35-211_V2.5-ENU exam will have a deep understanding of these topics and will be able to design, deploy, and maintain network access solutions in a variety of settings.
H35-211_V2.5-ENU Exam Dumps - PDF Questions and Testing Engine: https://guidetorrent.passcollection.com/H35-211_V2.5-ENU-valid-vce-dumps.html
